Building paper can turn water if it happens to penetrate the integrity of the roofing material.
Roofing nails penetrate soffit.
Both these two types of nail guns pneumatic ones are run by low pressure air compressors.
Roofing nails are made of galvanized steel to protect them from the elements.
Roofing nails should be long enough to penetrate the roofing material and go 19 mm into osb solid wood plywood or non veneer wood decking or through thickness of decking whichever is less.
Your contractor is correct in his interpretation of the national roofing contractors association standards as well as the ohio building code which state that nails must be long enough to penetrate through all roofing materials and extend through the underside of the deck or penetrate a wood plank by of an inch even if that surface is less than inch thick.
The condensation is caused by warm air leaking through the insulation between the top floor and the attic.
Use only zinc coated steel or aluminum 10 12 gauge barbed deformed or smooth shank roofing nails with heads 3 8 10mm to 7 16 12mm in diameter.
When installing roofing nails always make sure the nail is flush to the shingle.
This is a very thin black sheet that feels like a rough piece of wool.
This is a quick process and then the roofing material is applied.
When i installed the roofing on my house i did the same thing and in hind sight i could have used shorter nails but the building code in my area wants the roof nails to penetrate at least 3 4 inches into the sheathing.
The first thing that will happen here is the application of the building paper.
A fascia covers the front of a soffit.
Fasteners should be long enough to penetrate at least 3 4 19mm into wood decks or just through the plywood decks.
However siding nail guns can t drive coil nails and need several refills for long duration jobs.
Watch your head when your up there.
You need much more ventilation in the attic.
Roofing nail guns can drive coil nails and don t require frequent refilling.
Ice dams and moisture can ruin fascia boards that run along a roof line.
Yes quite normal for roofing nails to penetrate.
A countersunk nail will rip the shingle and a nail that is not completely nailed down will eventually work its way out.
Fasteners must be driven flush with the surface of the shingle.
The nails sticking through the roof sheathing is normal.