Roof Flashing Reglet

It is a groove cut within a mortar joint that receives counter flashing meant to cover surface flashing used to deflect water infiltration.

Roof flashing reglet.

The installation is done by cutting into the mortar between bricks or concrete on a wall or chimney and placing the top part of the reglet flashing in that gap. Finish setups or minimum quantities may be required. A reglet is found on the exterior of a building along a masonry wall chimney or parapet that meets the roof. A reglet flashing is a capping piece that is tucked into a joint and grinded into a mortar joint above the desired course of bricks.

The two piece reglet and flashing details are usually fabricated with an 050 1 25 mm reglet head and an 032 0 80 mm flashing. The two piece reglet and flashing details are usually fabricated with an 050 1 25 mm reglet head and an 032 0 80 mm flashing. Carlisle sure seal extruded termination bar aluminum 1 inch x 10 ft piece carton 50 500 ft. Special colors or finishes are available.

Special colors or finishes are available. This flashing is used with counter flashings to avoid leaks in one of the most crucial areas of a roof which is a ninety degree edge. Reglet can also refer to the counter flashing itself when it is applied on the surface known as face reglet or reglet flashing. Reglet flashing is installed between a wall or the back side of a parapet wall and a roof.

Thus it is an economical choice when appearance is the biggest concern. Finish setups or minimum quantities may be required. Discount roof flashing reglets fry reglet parts.